F4 Pro V3 Drone Flight Controller

F4 PRO V3:

Specification:
Item name: betaflight F4 V3 Flight Controller
Size: 36x36mm
Mount holes: 30.5x30.5mm

Features:
-STM32 F405 MCU
-Dshot support
-Drag and Drop OSD configured via Betaflight Configurator
-Smartaudio v2 support – Tune your PID’s and configure the omnibus F C from your Transmitter
-MPU6000 6 axis SPI Gyro & Accelerometer
-SBUS/PPM AND Spketrum dsm-x Ports
-SD card blackbox
-Baro(BMP280)
-5V 3A SBEC
-On-board Video Filter(only can supply 5V to VTX and Camera)
-SmartAudio V2 via tx6 on J10
-4×3 pin ESC pin layout
-IR pins for lap timing transponder

Package including:
1x betaflight F4 V3 Flight Controller

Note:

Within betaflight please use OmnibusF4SD target to update firmware

The V3 version now includes a built in BEC so you can power this board directly from your flight battery (up to 4S)

OmniNXT F7 Flight Controller OSD 5V8V BEC MPU6000 Gyro ICM20608 32khz 3-6S

The OmniNXT F7 is Airbot’s top of the range flight controller based on the newly designed NXT architecture. It uses the trusty MPU6000 Gyro with an additional ICM20608 on top. With the onboard damping box, the gyros run perfectly under 32k looptime. If you haven't already seen it, you should check out Josh's awesome video on different IMUs. The NXT also comes with 2 different BECs and 6 UARTs. OmniNXT F7 supports 3-6s LIPO direct input, built-in BEC for camera and power Filter.

Specification:

Item name: OmniNXT F7 Flight Controller

F7 MCU processors

Two gyros onboard: MPU6000 for sampling up to 8khz and ICM20608 for sampling up to 32khz

30.5x30.5mm Mounting holes

Supports 3-6S Lipo

Built-in 5V 1A BEC output (Buck)

Built-in 8V 1A BEC with LC filter output for the camera and VTX (Buck)

STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD)

Current sensor: NO

More caps to reduce power noise

Port for easy connection to Airbot 4-in-1 esc (SH1.0 8P)

Solder pads added for SmartAudio and Camera Control

Package Included:

1 x OmniNXT F7 Flight Controller

1 x 8P*1.0mm